Which type of mill is better for activated carbon grinding?

The main component of sexual carbon is carbon, which has strong adsorption properties and is usually used for industrial desulfurization and denitrification, domestic water purification or air purification. The use of activated carbon needs to be processed into powder first. The grinding process of activated carbon is as follows: the activated carbon is sent from the feeder to the hoist, and the hoist sends the activated carbon to the mill for grinding. After the powder that meets the particle size is selected by the classifier, it is collected by the collector, and the particles that meet the particle size requirements will continue to be ground in the grinder.

We found that in the grinding process of activated carbon, the grinder plays an important role. So,

what is the pulverizer used for grinding? Which one is better?

There are mainly Raymond mills, European mills, trapezoidal mills and vertical mills. Among them, Raymond mill, European version mill and trapezoidal mill all adopt the working principle of roller mill and ring mill. The difference is that the European version of the rolling mill and the body styling mill are upgraded products of the ordinary Raymond rolling mill, and the process has been improved. The vertical crusher adopts the working principle of roller compaction mill, which has relatively large output.
 
In activated carbon milling equipment, CLIRIK Raymond Vertical Mill (is an improved Raymond Mill, High Pressure Grinding Mill) through independent technology research and development. It is used in industrial milling. The finished product can reach 30-325 mesh, and its Capacity: 0-50tph. Compared with traditional Raymond mills, it has high productivity, convenient maintenance and low production costs. The specific advantages are:
1. High pressure spring design.The grinding device of the main unit is fixed with 1000-1500kg pressure springs. When the machine works the grinding roller , which under the action of high pressure spring and centrifugal force, rolls close up to grinding ring, its rollingpressureis 1.2 times higher than that of Raymond mill given an identical condition and its capacity increase 20% to 30%; When the grinding roller and grinding ring, stable capacity and fineness are guaranteed.
2. Smoothly vibration reduce design
The main unit and up side classifier are connected by spring,and sealed with soft belt,which reduce the noise and avoid sympathetic vibration,reduce the vibration of machine vastly.
3. Convenient vane adjust design.
Gap between vane end and shell are the main factor of product fineness ,this is a patent of this mill .
4. The machine has a strong material applicability , which suits for many kinds of material whose Moh’s hardness is less than 9.3.
5. Grinding device adopts superimposed multistage seal, sealed performance is good.

raymond mill

What should I pay attention to when buying Raymond Mill?

  • Equipment productivity is the key
For users of Raymond Mill, the purpose of purchasing equipment is production. If production is blocked, the equipment will also lose its original meaning. There are many reasons why equipment cannot operate normally. For example, equipment failures frequently occur, finished products cannot meet customer requirements, severe pollution during production is restricted by the management department, equipment is severely damaged and production cannot be continued. Many reasons are caused by one problem, namely the quality of the equipment. Quality includes the materials used in the equipment, the precision of equipment production and the technical level of the equipment. Old users of the mill know that the sealing performance of the roller bearing and the material of the roller is the key to ensuring the service life of the equipment.
  • Equipment manufacturer services must be in place
If the manufacturer's service we purchased is not in place, then we will encounter various problems during the operation stage of the equipment, how can the user simply replace the parts (the replacement of the parts is very simple, but there are still many problems that need to be paid attention to: for example: the removal of parts Sequence, whether the installation parts are in place, whether the installation method is correct, etc.), what maintenance issues need to be paid attention to after installation, etc., all require the cooperation of the manufacturer, so choosing a suitable and reliable manufacturer is also the key to production.
 
CLIRIK has a strong technical service team, a complete service system, pre-sales and after-sales full-process door-to-door, tracking services, users can trust and rest assured to buy, if you have the equipment needs, please feel free to contact us.